Hard Mechanical Engineering Quiz – Test Your Expertise

A concise set of challenging questions designed to evaluate deep knowledge in core mechanical engineering disciplines.

control systemsfinite elementthermodynamicskinematicsheat transfermaterial fatiguestress analysisvibration analysismachine designfluid mechanics
Difficulty:HARD

Quiz Details

Questions10
CategoryEngineering
DifficultyHARD
Start Quiz
Progress
0/0
0%

Quiz Questions

Answer all questions below and test your knowledge.

  1. 1

    What is the critical axial load that causes Euler buckling for a column with pinned‑pinned ends, modulus E, moment of inertia I, and length L?

    Question 1
  2. 2

    At approximately which Reynolds number does flow in a smooth circular pipe typically transition from laminar to turbulent?

    Question 2
  3. 3

    For a heat engine operating between 500 K and 300 K, what is the maximum theoretical efficiency according to Carnot?

    Question 3
  4. 4

    A plane stress element has σx = 80 MPa, σy = 20 MPa, and τxy = 30 MPa. What is the maximum principal stress?

    Question 4
  5. 5

    Which material typically exhibits a well‑defined fatigue limit, allowing infinite life below that stress?

    Question 5
  6. 6

    A gear train consists of a 20‑tooth pinion driving a 60‑tooth gear, which in turn drives a 30‑tooth gear on the output shaft. What is the overall gear ratio (input revolutions to output revolutions)?

    Question 6
  7. 7

    In an axial‑flow turbine, the degree of reaction is defined as the ratio of static enthalpy drop in the rotor to the total stage enthalpy drop. For a 50% reaction turbine, what is the static pressure rise in the rotor relative to the stage?

    Question 7
  8. 8

    A venturi meter has a throat diameter of 0.05 m and an upstream diameter of 0.10 m. If the pressure difference between these sections is 5000 Pa, what is the approximate flow velocity in the throat? (Assume water, ρ=1000 kg/m³, neglect losses.)

    Question 8
  9. 9

    Which heat‑treatment process introduces compressive residual stresses on the surface of a steel component to improve fatigue life?

    Question 9
  10. 10

    A hydraulic cylinder with a piston diameter of 0.1 m and a rod diameter of 0.04 m is subjected to a pressure of 12 MPa. What is the net extending force produced?

    Question 10

Never miss a quiz!

Daily challenges on Telegram

Join Now